If you\’re a DIY enthusiast who\’d like to update your power only project\’s connection to the latest USB standard, here is a 10-pack of USB C power only jack connectors! They\’re sturdy metal with 4 through-hole mounting tabs. It\’s really hard to rip these off a PCB. In an SMT line, you can just paste over the through-hole slots, and the pads will solder in place. We like this connector for its low-cost simplicity – it doesn\’t have all of the pins, just power: there are two ground, two vbus power, and the CC1 / CC2 pins. No D+ or D- data pins at all! That makes it a lot easier to solder and a bit less expensive too, great for folks who only want to get 5V power from a USB port. To use: connect ground and power to whatever you want to power with 5V, then tie two 5.1K resistors from CC1 and CC2 to ground (one resistor per CCx pin). Here\’s a tip on using drag soldering with these sorts of connectors: Technical Details Diagram 1 Diagram 2 Pinout